![]() To set a static IP for iDRAC, arrow down to LAN Parameters and press Enter.Īt the very top, you should see NIC Selection, which I recommend setting to Dedicated. Some of the newer servers now run iDRAC 9. This is an older server, so it’s still on iDRAC 6. You’ll definitely want to make sure iDRACx LAN is set to ON. ![]() It should say Press CTRL + E for Remote Access Setup within 5 sec. When you enter the iDRAC setup, there are quite a few options. You’ll need to quickly press CTRL + E as you only have about 5 seconds before the boot process continues. To get started, boot up your server and wait until you see the iDRAC configuration section pop up during the boot process. This entails setting up a static IP for iDRAC using either the dedicated port or by sharing the other LAN ports. There are a lot of things iDRAC can do, but in this article, I’ll be talking about how to setup the initial configuration for iDRAC so that you can log into the web interface. It’s software that is embedded directly onto the server and therefore allows you to control it without needing to install an OS or hypervisor. ![]() One feature I really wanted to learn how to use was iDRAC, which stands for Integrated Dell Remote Access. ![]() With my newly purchased refurbished Dell PowerEdge R710 server, I’ve been playing around with a lot of technical stuff lately.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |